JCB Rear Arm Lever / Joystick Boot - ORIGINAL
Original rubber cover (boot/gaiter) for the control lever. It covers the joysticks and levers responsible for the operation of the rear digging arm (or other hydraulic functions, depending on the machine). This component protects delicate control mechanisms from external contaminants, while simultaneously maintaining the aesthetics of the operator's workstation.
Technical Features:
- Material durability: Made of a high-grade rubber compound resistant to UV radiation, temperature changes, and repeated, extreme bending in all directions. It does not perish or dry rot as quickly as cheap aftermarket parts.
- Mechanics protection: Effectively blocks the entry of dust, sand, and moisture to ball joints, pushrods, and precision control valve sliders, preventing their rapid wear and the development of excessive play.
- Fit precision: The profile and rim dimensions perfectly match the shapes of the JCB control console, which guarantees a tight seating of the cover without the risk of it slipping off on its own.
Compatibility with JCB Machines:
| Backhoe Loaders |
210/212, 214/215/217, 2CX, 3CX ENTRY LEVEL (Global), 3CX, 3DX, 4/4C/4CN, 4CX, 4D, 4DX, 5CX |
| Agricultural Tractors |
FASTRAC 3000 (variants: 3200-1 [T3], 3200-2 [T3], 3230-1 [T3], 3230-2 [T3]) |
| Site Dumpers |
3 TONNE (variants: 3T-1 FRONT TIP MANUAL [T3], 3T-1 SWIVEL TIP MANUAL [T3]) |
| Rough Terrain Forklifts |
926, 930, 940 |
Technical Advice: A holed hydraulic lever boot is an open invitation for dirt, which instantly clings to the plungers and joints, leading to jammed or stiff controls. When replacing this component, be sure to take advantage of the "opened" console. Thoroughly blow out the accumulated dust with compressed air and clean the mechanisms of the remnants of old, sticky grease. Apply a fresh layer of dry Teflon or silicone lubricant – avoid aggressive petroleum-based greases, which in the long run can accelerate the degradation of the new rubber cover.
.png)
