Double Bevel Bolt-on Cutting Edge 2350x200x20 mm for JCB 3CX - GMOVE HARDOX 500 (993/99189)
A heavy-duty and highly wear-resistant double bevel bolt-on bucket cutting edge made of HARDOX 500 steel by GMOVE. This component features factory-drilled mounting holes and is specifically engineered for installation on the front loader bucket (instead of standard teeth) of JCB 3CX backhoe loaders. This profiled bolt-on hardox blade with dimensions of 2350 mm in length, 200 mm in width, and 20 mm in thickness provides a perfectly smooth working edge, essential for precise grading, ground leveling, and land clearing. The use of original Swedish steel with a nominal hardness of 500 HBW protects the bucket structure from premature wear, ensuring a significantly longer service life under the most challenging earthmoving conditions.
Technical Specifications:
- Part Number: 993/99189 (Alternative symbol: 993/99390 2350X200X20ZZ).
- Dimensions (Length x Width x Thickness): 2350 mm x 200 mm x 20 mm.
- Mounting Type: Bolt-on (With holes for plow bolts).
- Edge Profile: Double bevel (Reversible after one side wears out).
- Material: Original HARDOX 500 wear-resistant steel (GMOVE).
- Application: Reversible and protective cutting edge for front loader buckets.
Compatibility:
| Machine Type | Models and Variants |
|---|
| JCB Backhoe Loaders |
3CX (front loader bucket with pre-drilled holes) |
Workshop Technical Advice & Hardness Certificate: Every
hardox bucket edge we offer guarantees the highest quality. The hardness value presented below was obtained from a single sample representing a given batch. Depending on the variability of manufacturing processes, individual pieces may show slightly higher or lower values, remaining within the expected range around the measured result.
Mounting Tip: The double-bevel profile allows the cutting edge to be reused – once one edge is worn out, simply unbolt it, rotate it 180 degrees, and bolt it back on. During installation, always clean the underside of the bucket lip from dirt, rust, and old debris so that the new cutting edge seats perfectly flat across the entire 2350 mm length. Use only new plow bolts with a high hardness rating (minimum 10.9 or 12.9). Due to the high impact loads during operation, we recommend tightening the bolts with a torque wrench and checking them again after the first few hours of service.
.png)
